3pcs Windshield Removal Tool Kit Removal Wire Automotive Wind For Bonded

Removing windscreens takes patience, skill, and high-quality car windscreen removal tools you can rely on. You’ll get the urethane cutting wire you need to get through most windshield urethane. You also get: 275 mm panel-removal tool with handle, 330 mm Starter tool, 330 mm, 2x handles for cutting wire, 180 cm cutting wire, 240 mm Trim pad remover, pull scraper with handle and pull rope Operation Guide Remove all panels which are inside within the range of the adhesive material with the removal tool. In case of narrow space, heat up one tip of the cutting wire with a lighter and gently push the hot wire through the adhesive material. Therefore you need to hold the wire with a pliers. Shorten the cutting wire to desired length. Attach the tips of the wire to the handles by pushing the wire through the lower opening of the hollow shaft until it can be inserted into the bore hole at the upper part of the shaft. Snap the wire and push back the shaft into its handle. By going back and forth, the wire heats up and starts working through any adhesive material. Residual fillers or adhesives can be removed by using either the double hook handle or the pull scraper. A very simple glued windscreens s removal tools, works great on some older cars, also good for removing tailgate and rear quarter light windows Reinforced composite handles with heat-treated, chromed steel shafts for corrosion resistance